|
|
| |
|
| |
HALLITE SELLOS 755  |
| |
|
| |
INSTALLATION
Unlike PTFE seals ft is not generally necessary to use a cone to assemble the Type 755 onto the piston, the elastomeric material will stretch sufficiently without problems.
MATERIAL OPTIONS
The Holllte 755 Is supplied as standard with a polyester elastomer (Red 55D) but other material options can be supplied. These Include: Hydrolysis stabilised polyester elastomer (Grey 55D) Lubricated polyester elastomer (Brown 55D) Hydrolysis stabilised polyester elastomer (Red 72D) Hythane® 181 (a limited number of sizes are available in this material.) For fun details and availability please contact your local Hoilite sales office. |
DESIGN
The Hallite type 755 seal is a compact, low friction seal for light to medium duty hydraulic cylinders. Designed originally to the North American housing standards, the 755 Is an inch version of the metric type 754. It comprises of a very tough elastomeric face which Is pre-loaded by a square section ring (as North American convention).
It is recommended that an adequate bearing is mounted on both sides of the seal. See type 506 bearing strip data sheet.
FEATURES
• LOW BREAK-OUT AND OPERATING FRICTION LEVELS.
• RAPID RECOVERY OF FACE AFTER ASSEMBLY. UNUKE COMMON PTFE FACES, NO RE-SI7JNG IS REQUIRED.
• MORE TOLERANT TO DIRT AND CONTAMINATION THAN COMMON PTFE EQUIVALENTS.
• COMPATIBLE WITH MOST HYDRAULIC FLUIDS.
• EXCELLENT WEAR RESISTANCE.
• OPERATES ON A WIDE RANGE OF SURFACE FINISHES.
• IDEAL FOR USE WITH HAUJTE'S 506 BEARING STRIP
|
| |
| |
Programa de Dimensiones
Haga click en los ítems para ver el programa de dimensiones:
Ø Diam. Ext. de 12,00mm a 57,15mm
Ø Diam. Ext. de 60,00mm a 95,25mm
Ø Diam. Ext. de 100,00mm a 158,75mm
Ø Diam. Ext. de 160,00mm a 400,00mm |
| |
|
Ultima actualizacion 09-02-2010
|
|
