| |
FEATURES
• CUT TO SUIT • HIGH LOAD CAPABILITY • INFINITE LENGTH RANGE |
DESIGN
Hallite's 506 bearing strip provides the designer with an economical way to overcome a bearing problem and reduce costs. Hallite 506 strip can be used in any reciprocating, oscillating or rotary moving applications. It is produced by a unique process called Pultrusion using a woven fabric reinforced polyester resin material. This manufacturing method results in a dimensionally accurate rectangular section strip from which a bearing is cut. A standard range of cross section sizes is available and each cross section has a range of diameters to give you the opportunity to select the most suitable size for your needs. The common radial thickness allows any combination of widths to be used when groove Li needs to be larger than standard sizes. * For reciprocating applications use the compressive stress at yield for your design calcujations. For rotating shafts use the limiting P.V. values. It is suggested a 2:1 factor of safety is applied. Part numbers shown overleaf relate to the pre-coiled type 506 strip. If required we will be pleased to supply ready made bearings to your design. Independent tests have shown the typical properties of bearings made from type 506 strip are a suitable alternative for other, usually more expensive bearings, used in hydraulic cylinders. The material is compatible with a wide range of media, including H.F.A. Mineral Oil ASTM No. 1 and No.3 and Phosphate Ester. If you require any advice with the use of type 506, please contact your local Hallite sales office. Note: Tolerances for this product are specified on page 7/2. |
